Omron NX701-17 Series Troubleshooting Manual page 123

Event code Event name
54015448 hex Same Start Point
and End Point for
Circular Interpola-
tion
54015449 hex Circular Interpola-
tion Center Specifi-
cation Position Out
of Range
5401544A hex Instruction Execu-
tion Error Caused
by Count Mode
Setting
5401544C hex Parameter Selec-
tion Out of Range
5401544D hex Stop Method
Selection Out of
Range
5401544E hex Latch ID Selection
Out of Range for
Trigger Input Con-
dition
5401544F hex Setting Out of
Range for Writing
MC Setting
NJ/NX-series Troubleshooting Manual (W503)
Meaning
The start point and end • The start point and
point were the same when
the radius method was
specified for the MC_Move-
Circular2D (Circular 2D
Interpolation) instruction.
Or, the start point, end
point, and border point
were the same when the
• The start point, end
border point method was
specified.
The position specified for • The difference
the center point exceeded
the allowed range when the
center method was speci-
fied for the MC_MoveCircu-
lar2D (Circular 2D
Interpolation) instruction.
An instruction that cannot • An instruction that
be used when the Count
Mode is set to Rotary Mode
was executed for an axis
that was set to Rotary
Mode.
The parameter specified for • Instruction input
the ParameterNumber
input variable to a motion
control instruction is out of
range.
The parameter specified for • Instruction input
the StopMode input vari-
able to a motion control
instruction is out of range.
The parameter specified for • Instruction input
the TriggerInput::LatchID
input variable to a motion
control instruction is out of
range.
The parameter specified for • Instruction input
the SettingValue input vari-
able to a motion control
instruction is out of range.
• The parameter specifi-
Assumed cause
Maj Prt
end point were the
same when the radius
method was specified
for the MC_MoveCir-
cular2D (Circular 2D
Interpolation) instruc-
tion.
point, and border point
were the same when
the border point
method was specified
for the MC_MoveCir-
cular2D (Circular 2D
Interpolation) instruc-
tion.
between the distance
from the start point to
the center point and
the distance between
the end point to the
center point exceeded
the permitted value
specified for the cor-
rection allowance ratio
in the axes group set-
tings when the center
designation method
was specified for the
MC_MoveCircular2D
(Circular 2D Interpola-
tion) instruction.
cannot be used when
the Count Mode is set
to Rotary Mode was
executed for an axis
that was set to Rotary
Mode.
parameter exceeded
the valid range of the
input variable.
parameter exceeded
the valid range of the
input variable.
parameter exceeded
the valid range of the
input variable.
parameter exceeded
the valid range of the
input variable.
cation and the data
type of the setting
value do not agree.
3 Error Tables
Level
Refer-
ence
Min Obs Info
S W502
S W502
S W502
S W502
S W502
S W502
S W502
3-45
3