Omron NX701-17 Series Troubleshooting Manual page 261

Event code Event name
10410000 hex Control
Parameter
Error in Mas-
ter
10440000 hex Unit Calibra-
tion Value
Error
10450000 hex Actual Load
Calibration
Value Error
40200000 hex NX Unit Pro-
cessing Error
65130000 hex Sensor Dis-
connected
Error
NJ/NX-series Troubleshooting Manual (W503)
Meaning Assumed cause
An error occurred in For the NX bus of CPU
the control parame- Units
ters that are saved
• The power supply to the
in the master.
CPU Unit was turned
OFF while writing the
Unit operation settings
was in progress. Or
there is an error in the
area of the non-volatile
memory in the CPU Unit
in which the Unit opera-
tion settings for the rele-
vant NX Unit are saved.
For Communications Cou-
pler Units
• The power supply to the
Communications Cou-
pler Unit was turned
OFF while writing the
Unit operation settings
was in progress. Or
there is an error in the
area of the non-volatile
memory in the Commu-
nications Coupler Unit in
which the Unit opera-
tion settings for the rele-
vant NX Unit are saved.
There is an error in • There is an error in the
the area in which area of the non-volatile
the Unit calibration memory in which the
values are saved. Unit calibration values
are saved.
There is an error in • There is an error in the
the area in which area of the non-volatile
the actual load cali- memory in which the
bration values are actual load calibration
saved. values are saved.
A fatal error • An error occurred in the
occurred in an NX software.
Unit.
A disconnection • Wiring with the load cell
with the load cell is not connected.
was detected.
• Wiring with the load cell
is broken.
• The input signal
exceeds the input con-
version range.
• Load cell failure.
3 Error Tables
Level
Maj Prt Min Obs Info
S
S
S
S
S
Reference
W565
3
W565
W565
W565
W565
3-183