Omron NX701-17 Series Troubleshooting Manual page 161

Event code Event name
546C0000 hex Master Sync
Start Posi-
tion Setting
Out of Range
546D0000 hex Slave Sync
Start Posi-
tion Setting
Out of Range
546E0000 hex Duplicate
Latch ID for
Trigger Input
Condition
546F 0000 hex Jerk Over-
ride Factor
Out of Range
54700000 hex Accelera-
tion/Deceler-
ation
Override
Factor Out of
Range
54710000 hex First Position
Method
Specification
Out of Range
54720000 hex Motion Con-
trol Instruc-
tion Re-
execution
Disabled
(First Posi-
tion Method)
54740000 hex Unused Axis
Specification
for Auxiliary
Axis
NJ/NX-series Troubleshooting Manual (W503)
Meaning Assumed cause
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
MasterSyncPosi- input variable.
tion input variable
to a motion control
instruction is out of
range.
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
SlaveSyncPosition input variable.
input variable to a
motion control
instruction is out of
range.
The same latch ID • The same latch ID is used
was specified for simultaneously for more than
more than one one of the following instruc-
motion control tions: MC_TouchProbe (Enable
instruction. External Latch) instruction,
MC_MoveLink (Synchronous
Positioning) instruction, and
MC_MoveFeed (Interrupt Feed-
ing) instruction.
• The MC_AbortTrigger (Disable
External Latch) instruction was
executed to cancel a latch that
was used by an instruction
other than the MC_Touch-
Probe (Enable External Latch)
instruction.
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
JerkFactor input input variable.
variable to a motion
control instruction is
out of range.
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
AccFactor input input variable.
variable to a motion
control instruction is
out of range.
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
StartMode input input variable.
variable to a motion
control instruction is
out of range.
An attempt was • A parameter for an input vari-
made to change the able that cannot be changed for
StartMode input re-execution was changed.
variable when re-
executing a motion
control instruction.
(This input variable
cannot be changed
when re-executing
an instruction.)
The axis specified • The axis specified for the Auxil-
for the Auxiliary iary input variable to the instruc-
input variable to a tion is an unused axis.
motion control
instruction is an
unused axis.
3 Error Tables
Level
Maj Prt Min Obs Info
S W508
S W508
S W508
S W508
S W508
S W508
S W508
S W508
Reference
3
3-83