Omron NX701-17 Series Troubleshooting Manual page 163

Event code Event name
547E0000 hex Circular Inter-
polation Set-
ting Out of
Range
547F 0000 hex Auxil-
iary/Slave
Axis Num-
bers Not in
Ascending
Order
54800000 hex Cam Table
Property
Ascending
Data Error at
Update
54810000 hex MC_Write
Target Out of
Range
54820000 hex Master Travel
Distance
Specification
Out of Range
54830000 hex Master Dis-
tance in
Acceleration
Specification
Out of Range
54840000 hex Master Dis-
tance in
Deceleration
Specification
Out of Range
54870000 hex Execution
Mode Selec-
tion Out of
Range
NJ/NX-series Troubleshooting Manual (W503)
Meaning Assumed cause
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
CircAxes input vari- input variable.
able to a motion
• The axes that were specified in
control instruction is
CircAxes are not included in the
out of range.
composition axes in the Axes
Group Settings.
• The same axis was specified
for both axes of CircAxes.
The values of the • The parameters for the Auxil-
parameters for the iary and Slave input variables
Auxiliary and Slave to the instruction are not in
input variables to a ascending order.
motion control
instruction are not
in ascending order.
A phase that was • A phase that was not in
not in ascending ascending order was found
order was found when calculating the number of
during calculating valid data.
the number of valid
• After calculations, the number
data. Or, after cal-
of valid data is 0.
culations, the num-
ber of valid data is
0.
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
Target input vari-
input variable.
able to a motion
control instruction is
out of range.
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
MasterDistance input variable.
input variable to a
motion control
instruction is out of
range.
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
MasterDistance- input variable.
ACC input variable
to a motion control
instruction is out of
range.
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
MasterDistance- input variable.
DEC input variable
to a motion control
instruction is out of
range.
The parameter • Instruction input parameter
specified for the exceeded the valid range of the
ExecutionMode input variable.
input variable to a
motion control
instruction is out of
range.
3 Error Tables
Level
Maj Prt Min Obs Info
S W508
S W508
S W508
S W508
S W508
S W508
S W508
S W508
Reference
3
3-85