Radio Commands - Siemens scalance WLC711 Reference Manual

bcast_disassoc
country Ireland
no lldp
led-mode normal
lbs-status enabled
secure-tunnel disable
ipmcast-assembly disabled
The following example displays the load groups:
WLC.siemens.com
Load Groups:
loadgroup1
loadgroup2
The following example displays the contents of the professional-antenna context:
WLC.siemens.com
Professional Antenna Install:
Antenna
Radio 1 Left Antenna Type
Radio 1 Middle Antenna Type
Radio 1 Right Antenna Type
Radio 2 Left Antenna Type
Radio 2 Middle Antenna Type
Radio 2 Right Antenna Type
telnet
Use the command to enable telnet access to the Wireless AP. Use the no form of the command
telnet
to disable it. The
telnet
the CLI.
telnet no telnet
Parameters
None
Example
The following example enables telnet access to the Wireless AP:
WLC.siemens.com

Radio Commands

The commands in this section are common to multiple radio1 and radio2 commands in the ap:defaults:
11n, ap:defaults, , ap:defaults:ap37xx, ap:defaults:ap38xx, ap:defaults:ap3801, ap:defaults:dualband,
ap:defaults:std, and ap:<serial> contexts.
•
admin-mode on page 119
•
antsel on page 119
SCALANCE WLC711 CLI Reference Guide
:ap:load-groups# show
:ap:1313254259510000:professional_antenna# show
Type
No Antenna
PRO-AI-DT05120 AG 5dBi 120deg 3f
PRO-AI-DX02360 AG 2dBi Omni
PRO-AI-DX02360 AG 2dBi Omni
PRO-AI-DX02360 AG 2dBi Omni
PRO-AI-DX07025 AG 7dBi 27/30deg
command is accessible from the ap:dualband, std, and ap:<serial> contexts of
:ap:0409920201204003# telnet
ap Commands
telnet
117