Default-Role - Siemens scalance WLC711 Reference Manual
Hide thumbs
Also See for scalance WLC711:
- Getting started (100 pages) ,
- Compact operating instructions (30 pages) ,
- Maintenance manual (73 pages)
Table of Contents
Advertisement
replay_interval
Use the
replay_interval
replay_interval
replay_interval 0-1000
Parameters
0-1000
Examples
The following example sets the DAS replay interval to 60 seconds:
WLC.siemens.com
default-role
The
default-role
replaces the former default-policy of previous releases. The vnsmode:default-role context provides
commands for the configuration of the default-role.
The default-role definitions provide a placeholder for completion of incomplete (no-change) roles
(policies) for the VNS being configured. Refer to
commands.
The default-role specifies:
•
A topology to use when a VNS is created using a role (non-auth role) that does not specify a
topology. The default assigned topology is the Bridge Traffic Locally at AP topology.
•
An inbound and outbound rate control profile. The default rate control profile is "Unlimited".
•
A set of filters. The default filter set is a single deny all rule.
After you complete configuration changes for the default-role, run the
the vnsmode:default-role context to implement the changes.
The following commands are available in the vnsmode:default-role context:
•
show
on page 243
•
sync
on page 244
•
topology-name
•
acfilters
on page 245 — See for commands in the vnsmode:default-role:acfilters context.
•
apfilters
on page 245 — See for commands in the vnsmode:default-role:apfilters context.
show
Use the
command to display the default-role configuration information for the current
show
vnsmode:default-role context. The
context.
SCALANCE WLC711 CLI Reference Guide
command to configure the DAS replay interval, measured in seconds. The
command is available from the vnsmode:das context.
Specifies the DAS replay interval, measured in seconds.
:vnsmode:das# replay_interval 60
command moves you into the vnsmode:default-role context. The default-role
on page 244
command is accessible from within the vnsmode:default-role
show
VNS Commands (vnsmode)
role Commands
for a complete discussion of role
apply
replay_interval
command before exiting
243
Advertisement
Table of Contents
