Siemens scalance WLC711 Reference Manual page 126

Example
The following example configures the maximum basic rate to 24 Mbps:
WLC.siemens.com
max-distance
Use the
max-distance
participate in a WDS. This value ensures that the acknowledgement of communication between APs
does not exceed the timeout value predefined by the 802.11 standard. If the link distance between APs
is greater than the default value of 100 meters, configure the maximum distance up to 15,000 meters so
that the software increases the timeout value proportionally with the distance between APs. The
command is accessible from most radio contexts of the CLI.
distance
Do not change the default setting for any radio that is not participating in a Mesh or WDS.
max-distance value
Parameters
value
Example
The following example sets the maximum distance between APs to 1500 meters:
WLC.siemens.com
maxoprate
Use the
maxoprate
the :defaults:dualband, ap:defaults:std, and ap:<serial> radio contexts of the CLI.
maxoprate value
Parameters
value
Example
The following example sets the maximum operational rate to 24Mbps:
WLC.siemens.com
SCALANCE WLC711 CLI Reference Guide
:ap:defaults:dualband:radio1# maxbrate 24
command to set the maximum link distance, in meters, between APs that
Specifies the maximum distance between APs in meters. The default is 100 meters.
You can enter a value from 100 to 15000 meters.
:ap:defaults:11n:radio2# max-distance 1500
command to set the maximum operational rate. The maxoprate is accessible from
Specifies the maximum operational rate value (in Mpbs). The value must always be
greater than or equal to the value of maxbrate.
When the mode is b, valid values are: 1, 2, 5.5, 11.
When the mode is bg, valid values are :1, 2, 5.5, 6, 9, 11, 12, 18, 24, 36, 48, and 54.
When the mode is g or a, valid values are: 6, 9, 12, 18, 24, 36, 48, and 54.
:ap:defaults:dualband:radio1# maxoprate 24
ap Commands
max-distance
max-
126