Siemens scalance WLC711 Reference Manual page 86

Examples
This example enables the
WLC.siemens.com
defaults
The command moves you into the defaults context, which contains commands to configure
defaults
the Wireless AP's default settings. The
CLI.
As the Wireless APs discover and register with the controller, they inherit the properties of the default
Wireless AP setting. Since these defaults must apply to multiple AP platforms, they consist only of
values that are supported on all platforms. To apply options individually to an AP, you can modify the
default Wireless AP settings on that AP either via the Wireless Assistant GUI or the CLI <serial> context.
The following commands are available in the ap:defaults context:
•
11n on page 86 — See for commands in the ap:defaults:11n context.
•
ap37xx on page 87 — See for commands in the ap:defaults:ap37xx context.
•
ap38xx on page 87 — See ap38xx for commands in the ap:defaults:ap38xx context.
•
ap3801 — See ap3801 for commands in the ap:defaults:ap3801 context.
•
assign on page 88 — See assign for commands in the ap:defaults: context.
•
dualband on page 89 — See for commands in the ap:defaults:dualband context.
•
learnac on page 90
•
aclist on page 146
•
move
•
std on page 90 — See for commands in the ap:defaults:std context.
11n
The command moves you into context 11n, which contains commands to configure the default AP
11n
settings for the Wireless 802.11n AP. The
CLI.
The following commands are available in the ap:defaults:11n context:
•
balanced-power
•
bcast_disassoc
•
client_session on page 108
•
country on page 109
•
ipmcast-assembly
•
lbs-status on page 109
•
led-mode on page 110
•
lldp on page 111
•
persistent on page 111
•
poll_timeout on page 112
SCALANCE WLC711 CLI Reference Guide
mac-list-sync-mode
:ap:blacklist# mac-list-sync-mode enable
defaults
11n
on page 108
on page 109
:
command is accessible from the ap context of the
command is accessible from the ap:defaults context of the
ap Commands
defaults
86