Siemens scalance WLC711 Reference Manual page 266

Parameters
VNS-name
Example
The following example changes the name of VNS1 to VNS2, then uses the
information for the current VNS, including its name:
WLC.siemens.com
WLC.siemens.com
WLC.siemens.com
WLANS service: test
Non-authenticated: p4
Authenticated: same as non-authenticated
Restrict available role set: disable
Enable status: enable
Synchronize: disable
Name: VNS2
status
Use the command in the vnsmode:<named-VNS> context to enable or disable the current VNS.
status
After you run the
status
status (enable | disable)
Parameters
enable
disable
Examples
This example disables the current VNS named VNS1:
WLC.siemens.com
WLC.siemens.com
sync
Use the command in the vnsmode:<named-VNS> context to enable or disable automatic
sync
synchronization of this VNS across paired controllers. Refer to the Wireless User Guide for more
information about synchronization of VNSs.
After you run the
sync
sync (enable | disable)
SCALANCE WLC711 CLI Reference Guide
Specifies the new name for the current VNS.
:vnsmode:VNS1# name VNS2
:vnsmode:VNS1# apply
:vnsmode:VNS1# show
command, run the
apply
Enables the VNS.
Disables the VNS.
:vnsmode:VNS1# status disable
:vnsmode:VNS1# apply
command, run the
apply
VNS Commands (vnsmode)
show
command to implement the changes.
command to implement the changes.
status
command to display
266