Siemens scalance WLC711 Reference Manual page 344

•
name on page 370
•
show on page 371
•
strict-subnet on page 372
•
sync on page 372
3rd-party
Use the
3rd-party
physical topology can have 3rd-party set to enable. The
topology:<named-topology> context of the CLI for physical topologies.
3rd-party enable | disable
Parameters
enable
disable
Example
The following example enables a 3rd-party port on a physical topology:
WLC.siemens.com
WLC.siemens.com
Name: esa0
3rd party: enable
l2
Use the command to enter the topology:<named-topology>:l2 context of the CLI for b@ac, b@ap,
l2
physical, and routed topologies. The l2 context allows you to configure the Layer 2 functions of the
topology.
The following commands are available in the topology:<named-topology>:l2 context.
•
arp-proxy on page 344
•
multicast on page 345 — See
topology>:l2:multicast context.
•
port on page 347
•
show on page 348
•
tagged on page 348
•
vlanid on page 349
arp-proxy
Use the
arp-proxy
to which this topology is applied are enabled/disabled as ARP proxies. The
available from the topology:<named-topology>:l2: context of the CLI for b@ap topologies.
SCALANCE WLC711 CLI Reference Guide
command to enable or disable a third-party port in a physical topology. Only one
Enables a 3rd-party port on the specified physical topology.
Disables a 3rd-party port on the specified physical topology.
:topology:esa0# 3rd-party enable
:topology:esa0# show
multicast on page 345 for commands in the topology:<named-
command to enable or disable the AP as an ARP proxy for this topology. Only APs
topology Commands
command is available from the
3rd-party
arp-proxy
3rd-party
command is
344