Siemens scalance WLC711 Reference Manual page 185

•
reclassify on page 186
•
show on page 187
authorized-ap
Use the
authorized-ap
this context by their BSSID (Basic Service Set ID), which is the same as their MAC address. The
command is accessible from the mitigator:maintenance context of the CLI.
authorized-ap
After you run the
authorized-ap
authorized-ap (bssid [desc string]) | (bssid delete)
Parameters
bssid
desc string
delete
Example
The following example adds testap1 by its BSSID: 11:11:22:22:33:33 as an authorized AP:
WLC.siemens.com
testap1
WLC.siemens.com
The following example deletes the AP with BSSID: 11:11:22:22:33:33 from authorized status:
WLC.siemens.com
WLC.siemens.com
friendly-ap
Use the
friendly-ap
context by their BSSID (Basic Service Set ID), which is the same as their MAC address. The
command is accessible from the mitigator:maintenance context of the CLI.
ap
After you run the
friendly-ap
friendly-ap (bssid [ssid string] [desc string]) | (bssid delete)
Parameters
bssid
ssid string
desc string
delete
SCALANCE WLC711 CLI Reference Guide
command to add, update, or remove an authorized AP. APs are identified in
command, run the
The MAC address of the AP.
An optional alphanumeric character string describing the AP.
Removes the AP identified from BSSID from authorized status.
:mitigator:maintenance# authorized-ap 11:11:22:22:33:33 desc
:mitigator:maintenance# apply
:mitigator:maintenance# authorized-ap 11:11:22:22:33:33 delete
:mitigator:maintenance# apply
command to add, update, or remove a friendly AP. APs are identified in this
command, run the
The MAC address of the AP.
An optional alphanumeric character string identifying the subsystem (SSID).
An optional alphanumeric character string describing the AP.
Removes the AP identified by the BSSID from friendly AP status.
command to implement the change.
apply
command to implement the change.
apply
Radar Commands
authorized-ap
friendly-
185