Siemens scalance WLC711 Reference Manual page 283

After you run the
aplist
[no] aplist ap-name radio1|radio2|both
Parameters
ap-name
radio1|radio2|both
Usage
This command is only available when the WLAN service type is STD.
Example
The following example adds an AP by serial number to the WLAN service named "test" and then
displays the list of Wireless APs:
WLC.siemens.com
WLC.siemens.com
WLC.siemens.com
Wireless AP Services:
Wireless AP: 0500000000000000 both
aplist-wds (WDS)
Use the
aplist-wds
configuration. The
of the CLI when the WLAN service type is WDS.
aplist-wds (Mesh) on page 284 for information about using the command to configure a dynamic mesh
WLAN service.
Use this command to configure the following:
•
Role on radio 1
•
Role on radio 2
•
Preferred parent
•
Backup parent
•
Work group bridging
After you run the
aplist-wds
aplist-wds ap-name ((radio1 none|child|parent|both radio2 none|child|parent|
both)|(both none|child|parent|both)) [pref-parent ap-name | Any-Parent] [backup-
parent ap-name | Any-Parent] [wkgbridge on|off]
no aplist-wds ap-name radio1|radio2|both
SCALANCE WLC711 CLI Reference Guide
command, run the
Specifies the name of the AP to add or remove from the WLAN service.
The no form of the command removes the AP
Specifies to use radio1, radio2, or both with the WLAN service
:wlans:test# aplist 0500000000000000 both
:wlans:test# apply
:wlans:test# show aplist
command to add or remove an AP to or from a WDS type WLAN service
command is accessible from the wlans:<WLAN-service-name> context
aplist-wds
command, run the
command to implement the changes.
apply
command to implement the changes.
apply
wlans Commands
aplist-wds (WDS)
283