Siemens scalance WLC711 Reference Manual page 358

Example
The following example sets the maximum time to keep a DHCP-ed IP address to 2592000 seconds:
WLC.siemens.com
WLC.siemens.com
WLC.siemens.com
mode
Use the command to specify the type of DHCP server to be used. The
mode
from the topology:<named-topology>:l3:dhcp context of the CLI for b@ac, physical, and routed
topologies.
After you run the
mode
For b@ac topologies:
mode local | relay | none
For physical topologies:
mode local | none
For routed topologies:
mode local | relay
Parameters
local
relay
none
Example
The following example configures the routed topology named routed2 to use a local DHCP server on
the controller:
WLC.siemens.com
WLC.siemens.com
range
Use the command to configure the DHCP pool of addresses. The
range
from the topology:<named-topology>:l3:dhcp context of the CLI for b@ac, physical, and routed
topologies. This command is visible only when mode is set to local. See
After you run the
range
range A.B.C.D A.B.C.D
Parameters
A.B.C.D
A.B.C.D
SCALANCE WLC711 CLI Reference Guide
:topology:routed2:l3:dhcp# mode local
:topology:routed2:l3:dhcp# lease-max 2592000
:topology:routed2:l3:dhcp# apply
command, run the
apply
Indicates that the controller itself acts as the DHCP server.
Indicates that a DHCP relay server will be used.
Indicates that the Wireless Appliance will not treat the DHCP messages specially.
:topology:routed2:l3:dhcp# mode local
:topology:routed2:l3:dhcp# apply
command, run the
apply
Specifies the first IP address in the IP address range.
Specifies the last IP address in the IP address range.
command to implement the changes.
range
mode
command to implement the changes.
topology Commands
mode
command is available
mode
command is available
on page 358.
358