Siemens scalance WLC711 Reference Manual page 112

Usage
Enable this feature (if using a bridged at AP VNS) to ensure the Wireless AP's radios continue providing
service if the Wireless AP's connection to the controller is lost. If this feature is enabled, it allows the
Wireless AP to start a bridged at AP VNS even in the absence of a wireless controller.
After you run the
persistent
persistence value.
Example
The following example enables service persistence:
WLC.siemens.com
poll_timeout
Use the
poll_timeout
the Wireless Appliance before rebooting. The
ap:<serial> and ap:defaults:11n, ap37xx, ap38xx, ap3801, and std contexts of the CLI.
After you run the
poll_timeout
timeout value.
poll_timeout value
Parameters
value
Example
The following example sets the poll timeout to 20 seconds:
WLC.siemens.com
radio1
The command refers to the radio1 context, which contains commands to configure Radio 1 on
radio1
each Wireless AP. The
ap38xx, ap3801, and std contexts of the CLI;
and radio mode.
•
admin-mode on page 119
•
antsel on page 119
•
atpc on page 119
•
att on page 120
•
beaconp on page 120
SCALANCE WLC711 CLI Reference Guide
command, run the
:ap:defaults:11n# persistent
command to set the amount of time the Wireless AP waits for a response from
poll_timeout
command, run the
Specifies the amount of time, in seconds, to wait for a response from the Wireless
Appliance before rebooting. The range for poll_timeout value is from 3 to 600
unless the controller is in an availability pair without fast failover enabled.
:ap:defaults:11n# poll_timeout 20
command is accessible from the ap:<serial> and ap:defaults:11n, ap37xx,
radio1
radio
command to implement the change in mode
apply
command is accessible from the
command to implement the change in poll
apply
command options differ depending on the AP type
ap Commands
poll_timeout
112