Siemens scalance WLC711 Reference Manual page 309
Hide thumbs
Also See for scalance WLC711:
- Getting started (100 pages) ,
- Compact operating instructions (30 pages) ,
- Maintenance manual (73 pages)
Table of Contents
Advertisement
Example
The following example enables the inclusion of AP Identification information in messages to the
RADIUS server:
WLC.siemens.com
WLC.siemens.com
WLC.siemens.com
AP as VSA attribute: enable
vsa-egress
Use the
vsa-egress
RADIUS server. The
context of the CLI.
After you run this command, run the
vsa-egress enable | disable
Parameters
enable | disable
Usage
The
command is not available when the authentication mode is guestportal. When the
vsa-egress
authentication mode is disabled, MAC must be enabled for this command to be available. For more
information, see
mode
Example
The following example enables the inclusion of egress rate control information in messages to the
RADIUS server:
WLC.siemens.com
WLC.siemens.com
WLC.siemens.com
Egress rate control as VSA attribute: enable
vsa-ingress
Use the
vsa-ingress
RADIUS server. The
context of the CLI.
After you run this command, run the
vsa-ingress enable | disable
SCALANCE WLC711 CLI Reference Guide
:wlans:test:auth# vsa-ap enable
:wlans:test:auth# apply
:wlans:test:auth# show vsa-ap
command to include egress rate control information in the message to the
command is accessible from the wlan:<WLAN-service-name>:auth
vsa-egress
command to implement the changes.
apply
Specifies to enable or disable the inclusion of egress rate control
information in messages to the RADIUS server
on page 302.
:wlans:test:auth# vsa-egress enable
:wlans:test:auth# apply
:wlans:test:auth# show vsa-egress
command to include ingress rate control information in the message to the
command is accessible from the wlan:<WLAN-service-name>:auth
vsa-ingress
command to implement the changes.
apply
wlans Commands
vsa-egress
309
Advertisement
Table of Contents
