Siemens scalance WLC711 Reference Manual page 121

ch
Use the command to set a fixed channel for this radio. The
ch
ap:<serial>: radio contexts of the CLI.
ch channel number
Parameters
channel number
Example
The following example sets the channel to 40 on Radio 1:
WLC.siemens.com
The following example checks available channels and then sets the channel to Auto on Radio 1:
WLC.siemens.com
Usage:ch (Auto|36|40|44|48|52|56|60|64|100|104|108|112|149|153|157|161)
Auto
36: ([5180],5200,5220,5240):13.5dBm
40: (5180,[5200],5220,5240):13.5dBm
44: (5180,5200,[5220],5240):13.5dBm
48: (5180,5200,5220,[5240]):13.5dBm
52: ([5260],5280,5300,5320):15.5dBm
56: (5260,[5280],5300,5320):15.5dBm
60: (5260,5280,[5300],5320):15.5dBm
64: (5260,5280,5300,[5320]):15.5dBm
100: ([5500],5520,5540,5560):15.5dBm
104: (5500,[5520],5540,5560):15.5dBm
108: (5500,5520,[5540],5560):15.5dBm
112: (5500,5520,5540,[5560]):15.5dBm
149: ([5745],5765,5785,5805):21.5dBm
153: (5745,[5765],5785,5805):21.5dBm
157: (5745,5765,[5785],5805):21.5dBm
161: (5745,5765,5785,[5805]):21.5dBm
WLC.siemens.com
dcs
The command refers to the dcs context, which contains commands to configure the Dynamic
dcs
Channel Selection (DCS) feature. The
The commands are described in the
dcs
SCALANCE WLC711 CLI Reference Guide
Specifies the number of the channel this radio uses. Possible channel
ranges are:
•
2.4GHz radio: 1-14
•
5 GHz radio: 36-165
Actual channels available depend on AP type, controller license, country,
antenna settings, AP environment, and radio mode. It is advisable to set
the channel to Auto and allow the controller to ensure the best overall
wireless coverage for the environment.
:ap:<serial>:radio1# ch 40
:ap:1313254259510000:radio1# ch
:ap:<serial>:radio1# ch Auto
command is accessible from all radio contexts of the CLI.
dcs
DCS Commands
command is accessible from the
ch
on page 140.
ap Commands
ch
121