Siemens scalance WLC711 Reference Manual page 303

add-vlan
add-vns
apply
cp-https
end
exit
extredir
extsecret
fqdn
identity
logout
send-login
show
Example
The following example sets the authentication mode to external captive portal:
WLC.siemens.com
WLC.siemens.com
WLC.siemens.com
Authentication mode: external
move
Use the command, from within the RADIUS server configuration command mode, to change the
move
position of a RADIUS server in the RADIUS server list. The
wlans:<WLAN-service-name>:auth context of the CLI.
After you run the
move
move current-position new-position
Parameters
current-position
new-position
Usage
You must be in RADIUS server configuration mode for the
command to enter RADIUS server configuration mode. For more information, see
config
page 296.
SCALANCE WLC711 CLI Reference Guide
Enable or disable adding containment VLAN (if any) of assigned role to redirection URL.
Enable or disable adding VNS Name to redirection URL.
Apply the command setting.
Enable or disable https support.
Return to the base mode.
Return to the previous mode.
Set external redirection URL.
Set the Shared Secret password.
Set the string to replace the Gateway IP address with a FQDN.
Set Identity.
Logout.
Type of CP redirection URL.
Display settings.
:wlans:test:auth# mode external
:wlans:test:auth# apply
:wlans:test:auth# show mode
command, run the
apply
Specifies the current position of the RADIUS server in the RADIUS server list. Valid
values are from 1 - 32.
Specifies the new position of the RADIUS server in the RADIUS server list. Valid
values are from 1 - 32.
command is accessible from the
move
command to implement the changes.
command to be available. Use the
move
wlans Commands
move
config on
303