Siemens scalance WLC711 Reference Manual page 306

protocol
Use the protocol command to configure the authentication protocol to be used with the RADIUS server
being configured. The
context of the CLI.
After you run the
protocol
protocol CHAP | PAP | MS-CHAP | MS-CHAP2
Parameters
CHAP
PAP
MS-CHAP
MS-CHAP2
Usage
You must be in RADIUS server configuration mode for the
command to enter RADIUS server configuration mode. For more information, see
config
page 296.
Example
The following example configures the CHAP protocol as the authentication protocol for this RADIUS
server:
WLC.siemens.com
WLC.siemens.com
radius-timeout-policy
The
radius-timeout-policy
specified policy from the list of configured policies to apply when the authentication request to the
RADIUS server times out. By default, the treat-like-access-reject policy is applied when authentication
requests time out.
After you run the
protocol
radius-timeout-policy policy name | treat-like-access-reject
Parameters
policy name
treat-like-access-
reject
SCALANCE WLC711 CLI Reference Guide
command is accessible from the wlans:<WLAN-service-name>:auth
protocol
command, run the
apply
Configures the Challenge Handshake Authentication Protocol as the authentication
protocol
Configures the Password Authentication Protocol as the authentication protocol
Configures the Windows specific version of CHAP as the authentication protocol
Configures the Windows specific version (Version 2) of CHAP as the authentication
protocol
:wlans:cnl-AAA:auth# protocol CHAP
:wlans:cnl-AAA:auth# apply
command within context wlan:<WLAN-service-name>:auth sets the
command, run the
apply
Specifies the name of the policy to apply when an authentication request times
out.
Specifies that the authentication request be treated as an authentication failure
when the authentication request times out. This is the default.
command to implement the changes.
command to be available. Use the
protocol
command to implement the changes.
wlans Commands
protocol
config on
306