vlanid
Use the
command to configure the VLAN ID of a physical topology or change the VLAN ID of
vlanid
b@ac or b@ap topologies. The
context of the CLI for b@ac, b@ap, and physical topologies.
vlanid 1-4094
Parameters
1-4094
Example
This following example sets the VLAN ID of the topology named test to 2:
WLC.siemens.com
l3
Use the
command to enter the topology:<named-topology>:l3 context of the CLI for Admin, b@ac,
l3
b@ap, physical, and routed topologies. The l3 context allows you to configure the Layer 3 functions of
the topology. The l3 context is now available in b@ac mode when l3presence is set to disable. For more
information, see
l3presence
The following commands are available in the topology:<named-topology>:l3 context.
•
ap-register
on page 350
•
cert
on page 350
•
copy-csr
on page 352
•
dhcp
on page 352 — See
dhcp context.
•
exceptions
on page 360 — See
topology>:l3:exceptions context.
•
foreign-ip
on page 364
•
gateway
on page 364
•
gateway-ipv6
on page 364
•
gen-certreq
on page 365
•
ip
on page 366
•
ipv6
on page 366
•
mgmt
on page 366
•
mtu
on page 367
•
netmask
on page 367 for named toplogies with disabled l3presence. See
•
nexthop
on page 368
•
ospf-advert
on page 368
•
ospf-cost
on page 369
•
show
on page 369
SCALANCE WLC711 CLI Reference Guide
command is available from the topology:<named-topology>:l2
vlanid
The VLAN ID that you want to assign to the topology.
:topology:test:l2# vlanid 2
on page 370.
dhcp
on page 352 for commands in the topology:<named-topology>:l3:
exceptions
on page 360 for commands in the topology:<named-
topology Commands
vlanid
l3presence
on page 370.
349