Siemens scalance WLC711 Reference Manual page 320
Hide thumbs
Also See for scalance WLC711:
- Getting started (100 pages) ,
- Compact operating instructions (30 pages) ,
- Maintenance manual (73 pages)
Table of Contents
Advertisement
Parameters
none
30-86400
Usage
The
wpa-broadcast-rekey
wpa-psk. For more information, see
Example
The following example sets the WPA re-key interval to 300 seconds:
WLC.siemens.com
WLC.siemens.com
WLC.siemens.com
Broadcast re-key interval (seconds): 300
wpa-v1
Use the
command to configure the WPA v1 encryption protocol. The
wpa-v1
accessible from the wlan:<WLAN-service-name>:priv context of the CLI.
After yourun the
wpa-v1
wpa-v1 auto | tkip | none
Parameters
auto | tkip | none
Usage
The
command is available when the privacy
wpa-v1
more information, see
Example
The following example displays the WPA v1 encryption protocol, sets the WPA v1 encryption protocol
to TKIP, and displays the setting:
WLC.siemens.com
WPA v.1 encryption is not enabled
WLC.siemens.com
WLC.siemens.com
WLC.siemens.com
WPA v.1 encryption:
wpa-v2
Use the
command to configure the WPA v2 encryption protocol. The
wpa-v2
accessible from the wlan:<WLAN-service-name>:priv context of the CLI.
SCALANCE WLC711 CLI Reference Guide
Disables the re-key interval for group keys
Specifies the re-key interval for group keys in seconds
command is available when the privacy
mode
on page 318.
:wlans:test:priv# wpa-broadcast-rekey 300
:wlans:test:priv# apply
:wlans:test:priv# show wpa-broadcast-rekey
command, run the
apply
Specifies the WPA v1 encryption protocol
mode
on page 318.
:wlans:test:priv# show wpa-v1
:wlans:test:priv# wpa-v1 tkip
:wlans:test:priv# apply
:wlans:test:priv# show wpa-v1
mode
on page 318 is set to wpa or
command to implement the name change.
mode
on page 318 is set to wpa or wpa-psk. For
wlans Commands
wpa-v1
command is
wpa-v1
command is
wpa-v2
320
Advertisement
Table of Contents
