Siemens scalance WLC711 Reference Manual page 321

After you run the
wpa-v2
wpa-v2 auto | aes | none
Parameters
auto | aes | none
Usage
The command is available when the privacy
wpa-v2
more information, see
Example
The following example displays the WPA v2 encryption protocol, sets the WPA v2 encryption protocol
to AES, and displays the setting:
WLC.siemens.com
WPA v.2 encryption is not enabled
WLC.siemens.com
WLC.siemens.com
WLC.siemens.com
WPA v.2 encryption: aes
wpa-v2-key-mgmt
Use the
wpa-v2-key-mgmt
command is accessible from the wlan:<WLAN-service-name>:priv context of the CLI.
key-mgmt
After you run the
wpa-v2-key-mgmt
change.
wpa-v2-key-mgmt none | both | pre-auth | okc
Parameters
none | both | pre-auth | okc
Usage
The
wpa-v2-key-mgmt
command is not available when the privacy mode is set to wpa-psk. For more information, see
page 318.
Example
The following example sets WPA v2 key management to both pre-authorization and Opportunistic Key
Caching (OKC):
WLC.siemens.com
WLC.siemens.com
SCALANCE WLC711 CLI Reference Guide
command, run the
apply
Specifies the WPA v2 encryption protocol
mode on page 318.
:wlans:test:priv# show wpa-v2
:wlans:test:priv# wpa-v2 aes
:wlans:test:priv# apply
:wlans:test:priv# show wpa-v2
command to configure WPA v2 key management options. The
command, run the
Specifies WPA v2 key management from these options,
respectively: none, both pre-authorization and Opportunistic Key
Caching (OKC), pre-authorization only, or OKC only
command is available when the privacy
:wlans:test:priv# wpa-v2-key-mgmt both
:wlans:test:priv# apply
command to implement the name change.
mode on page 318 is set to wpa or wpa-psk. For
command to implement the name
apply
mode on page 318 is set to wpa. This
wlans Commands
wpa-v2-key-mgmt
wpa-v2-
mode on
321