Siemens scalance WLC711 Reference Manual page 296
Hide thumbs
Also See for scalance WLC711:
- Getting started (100 pages) ,
- Compact operating instructions (30 pages) ,
- Maintenance manual (73 pages)
Table of Contents
Advertisement
This command is used to configure an external portal integration with NAC where HTTP traffic for non
authenticated users is tagged with a ToS override value. To integrate with NAC, you must use this
command to set the hexidecimal ToS override value on the controller to 0x40.
The external authentication mode must be set for this command to be available. For more information,
see
mode
on page 302.
Example
The following example enables ToS override with the hex value required for NAC integration (0x40):
WLC.siemens.com
40
WLC.siemens.com
WLC.siemens.com
ToS override for NAC Value(Hex):0x40
cdr
Use the
command to enable or disable the collection of Wireless Controller accounting information.
cdr
The
command is accessible from the wlan:<WLAN-service-name>:auth context of the CLI.
cdr
After you run the
cdr
cdr enable | disable
Parameters
enable | disable
Usage
The
command is available in all authentication modes. For more information, see
cdr
302.
Example
The following example enables the collection of Wireless Controller accounting information:
WLC.siemens.com
WLC.siemens.com
WLC.siemens.com
Collecting accounting information of Wireless Controller: enable
config
The
command defines RADIUS server settings for the named WLAN service in the current
config
context, overriding default RADIUS server configuration. The
wlan:<WLAN-service-name>:auth context of the CLI. Use this command to configure the RADIUS
server as an accounting, authentication or MAC authentication server.
config (radius (role acct|auth|mac) [prot CHAP | PAP | MS-CHAP | MS-CHAP2])
SCALANCE WLC711 CLI Reference Guide
:wlans:new-wlans:auth:captiveportal# tos-override enable tos
:wlans:new-wlans:auth:captiveportal# apply
:wlans:new-wlans:auth:captiveportal# show tos-override
command, run the
apply
Specifies to enable or disable the collection of Wireless Controller
accounting information
:wlans:test:auth# cdr enable
:wlans:test:auth# apply
:wlans:test:auth# show cdr
command to implement the changes.
command is accessible from the
config
wlans Commands
cdr
mode
on page
296
Advertisement
Table of Contents
