Siemens scalance WLC711 Reference Manual page 141

Examples
The following example shows the channel plan for Radio 1 is configured to include all non-DFS
channels:
WLC.siemens.com
The following example shows that the channel plan for radio 1 is customized to include channels 1, 2 and
3:
WLC.siemens.com
mode
Use the command to set the DCS mode. The
mode
contexts of the CLI.
In monitor mode, DCS generates an alarm, but does not change the channel, even if the noise and
interference levels on the current channel exceed their thresholds. In active mode, generates an alarm
and changes the channel if the noise and interference levels on the current channel exceed their
thresholds.
mode off | monitor | active
Parameters
off
monitor
active
Example
The following example sets DCS to active mode:
WLC.siemens.com
noise_threshold
Use the
noise_threshold
command is accessible from 11n, ap37xx, ap38xx, ap3801, dualband, std, and <serial> dcs contexts of
the CLI.
noise_threshold thrshold
Parameters
thrshold
SCALANCE WLC711 CLI Reference Guide
:ap:defaults:ap37xx:radio1:dcs# channel_plan all-non-dfs
:ap:defaults:ap37xx:radio2:dcs# channel_plan 1, 2, 3
Disables DCS
Monitors the noise and interference on the current channel
Enables DCS
:ap:defaults:ap37xx:radio1:dcs# mode active
command to set the DCS noise threshold. The
Specifies the DCS noise threshold in dB. The DCS noise threshold must be in the -95 to -50
range. ACS will scan for a new operating channel for the Wireless AP if the threshold is
exceeded.
command is accessible from all ap: radio dcs
mode
noise_threshold
ap Commands
mode
141