Siemens scalance WLC711 Reference Manual page 354

Examples
The following example enables DLS:
WLC.siemens.com
WLC.siemens.com
The following example disables DLS:
WLC.siemens.com
WLC.siemens.com
dls-address
Use the
dls-address
command is available from the topology:<named-topology>:l3:dhcp context of the CLI for b@ac and
routed topologies. This command is visible only when mode is set to local and dls is set to enable. See
mode on page 358.
dls-address (A.B.C.D | name) port 0-65535
Parameters
A.B.C.D | name
port 0-65535
Example
The following example sets the DLS address as 10.10.0.10:
WLC.siemens.com
WLC.siemens.com
WLC.siemens.com
dns
Use the command to specify the IP addresses for one or more DNS servers. The
dns
available from the topology:<named-topology>:l3:dhcp context of the CLI for b@ac, physical, and
routed topologies. This command is visible only when mode is set to local. See
After you run the
dns
dns (DNS server [,DNS server [...]]) | none
Parameters
DNS server
none
SCALANCE WLC711 CLI Reference Guide
:topology:test:l3:dhcp# mode local
:topology:test:l3:dhcp# dls enable
:topology:test:l3:dhcp# mode local
:topology:test:l3:dhcp# dls disable
command to configure the DLS server address and port. The
Specifies the qualified IPv4 address or name.
Specifies the DLS port number. This is an optional parameter. The default
port is 18433.
:topology:test:l3:dhcp# mode local
:topology:test:l3:dhcp# dls enable
:topology:test:l3:dhcp# dls-address 10.10.0.10
command, run the
apply
Specifies the IP address of a DNS server.
Clears the DNS server.
command to implement the changes.
topology Commands
dls-address
dls-address
command is
dns
mode on page 358.
354