Siemens scalance WLC711 Reference Manual page 115

•
ptype on page 136
•
rss-threshold on page 137
•
rts on page 137
•
stbc on page 137
•
tx_adjust_power
•
txbf on page 138
•
tx_max_power
•
tx_min_power
secure-tunnel
Use the
secure-tunnel
command is accessible from the ap:<serial> and ap:defaults:11n, ap37xx, ap38xx, and ap3801
tunnel
contexts of the CLI.
secure-tunnel disable | control | data | debug
Parameters
disable
control
data
debug
Usage
If enabling a secure tunnel, specify the type of traffic this tunnel will encrypt and carry: control traffic, or
control and data traffic. Secure tunneling can also be used for debug mode (keys are preserved without
encryption).
Note
For some AP models, the data option is not available.
Example
The following example enables a secure tunnel that encrypts control and data traffic on AP37xxs:
WLC.siemens.com
secure-tunnel-lifetime
Use the
secure-tunnel-lifetime
hours the tunnel remains enabled) of this tunnel. The
accessible from the ap:<serial> and ap:defaults:11n ap37xx, ap38xx, and ap3801 contexts of the CLI.
secure-tunnel-lifetime hours
SCALANCE WLC711 CLI Reference Guide
on page 138
on page 139
on page 139
command to enable or disable a secure tunnel on this site. The
Disables a secure tunnel between this AP and the controller.
Enables a secure tunnel by encrypting control traffic between the AP and the
controller.
Enables a secure tunnel by encrypting control and data traffic between the AP and
the controller.
Enables tunnel in debug mode, which preserves keys without encryption.
:ap:defaults:ap37xx# secure-tunnel data
command to enable or configure the lifetime (the number of
secure-tunnel-lifetime
ap Commands
secure-tunnel
secure-
command is
115