Siemens scalance WLC711 Reference Manual page 125

VI
VO
TVO
Example
The following example sets the retry values for the background transmission queue, best effort
transmission queue, video transmission queue, voice transmission queue, and the turbo voice
transmission queue as 1, 2, 3, 4, 5 respectively:
WLC.siemens.com
ldpc
Use the command to enable or disable 11n advanced LDPC feature on the radio of this context.
ldpc
The command is accessible from the ap:defaults:ap37xx, ap38xx, and ap3801 radio and
ldpc
ap:<serial>:radio contexts of the CLI.
ldpc enable | disable
Parameters
enable
disable
Example
The following example enables LDPC on Radio 2:
WLC.siemens.com
maxbrate
Use the
maxbrate
accessible from the :defaults:dualband, ap:defaults:std, and ap:<serial>:radio contexts of the CLI.
maxbrate value
Parameters
value
SCALANCE WLC711 CLI Reference Guide
Specifies the number of retries for the Video transmission queue.
Specifies the number of retries for the Voice transmission queue.
Specifies the number of retries for the Turbo Voice transmission queue.
:ap:defaults:dualband:radio1# hwretries 12345
Enables LDPC on this radio.
Disables LDPC on this radio.
:ap:defaults:ap37xx:radio2# ldpc enable
command to configure the maximum basic rate. The
Specifies the maximum basic rate value (in Mbps). The value must always be
greater than or equal to the value of minbrate.
If the mode is b or bg, valid values are 1, 2, 5.5, and 11.
If the mode is a or g, valid values are 6, 12, or 24.
ap Commands
command is
maxbrate
ldpc
125