apip
Use the
command when statically configuring a Wireless AP. In order to statically configure a
apip
Wireless AP, you must first run the
ap:<serial> context of the CLI.
apip IP Address netmask
[no] apip xxx.xxx.xxx.xxx xxx.xxx.xxx.xxx
Parameters
IP Address
netmask
Example
WLC.siemens.com
bgway
Use the
command when statically configuring a Wireless AP. In order to statically configure a
bgway
Wireless AP, you must first run the
the ap:<serial> context of the CLI.
bgway xxx.xxx.xxx.xxx
Parameters
xxx.xxx.xxx.xxx
Example
WLC.siemens.com
desc
Use the
command to change the description of the Wireless AP. The
desc
from the ap:<serial> context of the CLI.
desc new_description
Parameters
new_description
SCALANCE WLC711 CLI Reference Guide
no usedhcp
IP address of the Wireless AP
Netmask of the of the Wireless AP
:ap:7000001222222222 apip 10.205.3.131 255.255.255.0
no usedhcp
Specifies the default gateway of the network.
:ap:7000001222222222# bgway 10.205.3.2
Specifies a description of the Wireless AP.
command. The
command is accessible from the
apip
command. The
command is accessible from
bgway
ap Commands
apip
command is accessible
desc
149