Default-Height; Auto-Tracking - Siemens scalance WLC711 Reference Manual

location-engine (enable | disable)
Parameters
enable | disable
Examples
The following example enables the RF location engine:
WLC.siemens.com

default-height

Use the
default-height
floor plan does not specify a height for APs. The
location context of the CLI.
default-height centimeters
Parameters
centimeters
Usage
If the floor plan specifies a height for AP placement, that value will be used. If there is no floor plan, or
the floor plan does not specify AP placement heights, then this command applies. The default value for
the <centimeters> parameter is 3.
Examples
The following example sets the default height of APs to 06 centimeters:
WLC.siemens.com
WLC.siemens.com

auto-tracking

Use the
auto-tracking
the RF Location engine tracks and reports the location of all associated users (users with sessions on
the controller), up to the system limit (2,500).
The
auto-tracking
auto-tracking (enable | disable)
SCALANCE WLC711 CLI Reference Guide
Enables or disables the location engine on this controller.
:location# location-engine enable
command to set the default height of the APs from the floor, for use if the
Specifies the default height, in centimeters, of APs from the floor. Valid values are 0
- 1000.
:location# default-height 06
:location# apply
command to enable or disable auto-tracking. When auto-tracking is enabled,
command is accessible from the location context.
command is accessible from the
default-height
RF Location Commands
default-height
410