Siemens scalance WLC711 Reference Manual page 138

Parameters
enable
disable
Usage
•
n must be enabled in radio mode.
•
When STBC is enabled, antenna selection must be left-middle-right.
Example
The following example enables STBC on radio1:
WLC.siemens.com
tx_adjust_power
Use the
tx_adjust_power
the ATPC power levels from the calculated value. The
all ap radio contexts of the CLI. The
Ctrl (ATPC) is enabled.
tx_adjust_power value
Parameters
value
Example
The following example sets the Tx power adjust level to 0 dB:
WLC.siemens.com
txbf
Use the command to enable or disable the 11n advanced TXBF feature. The
txbf
accessible from the ap:defaults:ap37xx, ap38xx (radio2 only), ap3801, and <serial> radio contexts of the
CLI.
txbf enable | disable
Usage
When TXBF is enabled, antenna selection must be left-middle-right.
SCALANCE WLC711 CLI Reference Guide
Enables the 11n advanced STBC feature.
Disables the 11n advanced STBC feature
:ap:defaults:ap37xx:radio1# stbc enable
command to specify an offset to the Tx power level, which is used to adjust
tx_adjust_power
Specifies the value in dB.
:ap:defaults:ap37xx:radio1# tx_adjust_power 0
command is accessible from
tx_adjust_power
command is available only when Auto Tx Power
ap Commands
tx_adjust_power
command is
txbf
138