Siemens scalance WLC711 Reference Manual page 305

Parameters
A.B.C.D
vnsip
Usage
The NAS IP address defaults to the VNS IP address if this command is not used to specify a NAS IP
address.
You must be in RADIUS server configuration mode for the
command to enter RADIUS server configuration mode. For more information, see
config
page 296.
Example
The following example sets the NAS IP address for this RADIUS server configuration to the VNS IP
address for the cnl-AAA WLANS auth context:
WLC.siemens.com
WLC.siemens.com
WLC.siemens.com
NAS identifier: Use VNS IP address
password
Use the
password
server being configured. The
configuration mode from the wlans:<WLAN-service-name>:auth context of the CLI.
After you run the
password
password password
Parameters
password
Usage
You must be in RADIUS server configuration mode for the
command to enter RADIUS server configuration mode. For more information, see
config
page 296.
Example
The following example sets the MAC authentication password to techdoc:
WLC.siemens.com
WLC.siemens.com
SCALANCE WLC711 CLI Reference Guide
Specify the NAS IP address
Specifies that the VNS IP address should be used for the NAS IP address
:wlans:cnl-AAA:auth# nasip vnsip
:wlans:cnl-AAA:auth# apply
:wlans:cnl-AAA:auth# show nasip
command to specify the MAC authentication password to be used with the RADIUS
command is accessible from within the RADIUS server
password
command, run the
Specify the MAC authentication password
:wlans:cnl-AAA:auth# password techdoc
:wlans:cnl-AAA:auth# apply
command to be available. Use the
nasip
command to implement the changes.
apply
command to be available. Use the
password
wlans Commands
password
config on
config on
305