Siemens scalance WLC711 Reference Manual page 122

DCS commands do not require being followed with an
The following commands (or a subset of these) are available in the various dcs contexts:
•
channel_plan on page 140
•
mode on page 141
•
noise_threshold
•
occupancy_threshold
•
radio_channels
•
update_period
divrx
Use the command to select the best signal from the pair of diversity antennas for the reception
divrx
of packets from client devices. Select best for the best signal from both antennas, or Left or Right to
choose either of the two diversity antennas. The
ap:defaults:dualband, ap:defaults:std, ap:<serial>, contexts of the CLI.
divrx ( best | left | right )
Parameters
best | left | right
Example
The following example selects the right antenna:
WLC.siemens.com
divtx
Use the command to select the best signal from the pair of diversity antennas for the
divtx
transmission of packets to client devices. Select alternate to alternate between both antennas, or Left
or Right to choose either of the two diversity antennas. The
ap:defaults:dualband, ap:defaults:std, ap:<serial>, contexts of the CLI.
divtx ( alternate | left | right )
Parameters
alternate | left | right
Example
The following example selects the right antenna:
WLC.siemens.com
SCALANCE WLC711 CLI Reference Guide
on page 141
on page 142
on page 142
on page 143
Specifies the antenna for selection
:ap:defaults:dualband:radio1# divrx right
Specifies the antenna for selection.
:ap:defaults:dualband:radio1# divtx right
command.
apply
command is accessible from the
divrx
command is accessible from the
divtx
ap Commands
divrx
122