Named-Vns - Siemens scalance WLC711 Reference Manual
Hide thumbs
Also See for scalance WLC711:
- Getting started (100 pages) ,
- Compact operating instructions (30 pages) ,
- Maintenance manual (73 pages)
Table of Contents
Advertisement
Examples
The following example displays all existing rate control profiles:
WLC.siemens.com
Unlimited,0
lowspeed,200
<named-VNS>
Executing the
<named-VNS>
moves you into the vnsmode:<named-VNS> context, which contains commands to configure the
settings of the specified individual VNS.
The following commands are available in the vnsmode:<named-VNS> context:
•
auth
on page 264
•
non-auth
on page 265
•
name
on page 265
•
status
on page 266
•
sync
on page 266
•
wlans-name
on page 267
•
show
on page 267
auth
Use the
command to assign a default role for authenticated clients. This command is available
auth
from the vnsmode:<named-VNS> context.
After you run the
auth
auth non-auth | role-name
Parameters
non-auth
role-name
Usage
When you assign a default authenticated role to this VNS, the same rules apply as when a VNS is
created. That is — if the VNS's WLAN Service has a mode of:
•
"std" then the referenced role must have a topology of mode "b@ap," "b@ac," or "routed"
•
"3pap" then the referenced role must have a physical topology mode
SCALANCE WLC711 CLI Reference Guide
:vnsmode:rateprofile# show
command, where <named-VNS> refers to the name of a configured VNS,
command, run the
apply
Use the default role for non-authenticated clients for authenticated
clients.
Specifies the name of the role to use as the default role for
authenticated clients.
VNS Commands (vnsmode)
command to implement the changes.
<named-VNS>
264
Advertisement
Table of Contents
