Siemens scalance WLC711 Reference Manual page 97
Hide thumbs
Also See for scalance WLC711:
- Getting started (100 pages) ,
- Compact operating instructions (30 pages) ,
- Maintenance manual (73 pages)
Table of Contents
Advertisement
Examples
This example enables load control per radio for load group named radiogroup1, then specifies the
maximum number of clients for radio 1 and radio 2:
WLC.siemens.com
WLC.siemens.com
WLC.siemens.com
radio1-loadcontrol
Use the
radio1-loadcontrol
only. The
radio1-loadcontrol
context.
Radio Load Control activates only when the number of clients on the radio reaches the configured limit,
and does not disconnect any clients already connected. This is the default and preferred mode of load
control. Load control can be enabled on one radio and disabled on the other. Members of a WLAN load
control group are assigned to both radios and cannot be load controlled individually.
radio1-loadcontrol enable | disable
Parameters
enable | disable
Usage
For access to this command, the load group must be defined as a radio type load group.
Example
The following example enables load control on Radio1:
WLC.siemens.com
radio2-loadcontrol
Use the
radio2-loadcontrol
only. The radio2-load
context.
Radio Load Control activates only when the number of clients on the radio reaches the configured limit,
and does not disconnect any clients already connected. This is the default and preferred mode of load
control. Load control can be enabled on one radio and disabled on the other. Members of a WLAN load
control group are assigned to both radios and cannot be load controlled individually.
radio2-loadcontrol enable | disable
Parameters
enable | disable
Usage
SCALANCE WLC711 CLI Reference Guide
:ap:load-groups:radiogroup1# loadcontrol enable
:ap:load-groups:radiogroup1# radio-load radio1 40
:ap:load-groups:radiogroup1# radio-load radio2 50
command to enable or disable load control (soft load limits) on Radio1
command is accessible from the ap:load-groups:<named-loadgroup>
Enables or disables the load control function on Radio1.
:ap:load-groups:radiogroup1# radio1-loadcontrol enable
command to enable or disable load control (soft load limits) on Radio2
command is accessible from the ap:load-groups:<named-loadgroup>
control
Enables or disables the load control function on Radio2.
ap Commands
radio1-loadcontrol
97
Advertisement
Table of Contents
