Siemens scalance WLC711 Reference Manual page 176

After you enable or disable the Analysis Engine, run the
analysis
no analysis
Parameters
None
Example
The following command enables the Analysis Engine:
WLC.siemens.com
WLC.siemens.com
wcswip
Use the command to set the IP address of a Remote Data Collection Engine. Use the no format
wcswip
of the command to remove the IP address. The
context of the CLI.
Before using wcswip, InService and Guardian profiles should be deleted/removed if you want to use
Legacy style scanning.
C25 controller can not have additional RFDCs and does not support the
After you set the IP address of a Remote Data Collection Engine, run the
implement the changes.
wcswip IP Address [poll_interval(3-60) retries(0-20)]
no wcswip <IP Address>
Parameters
IP Address
poll_interval
retries
Examples
The following example sets the IP address of the Data Collection Engine and the required intervals, and
then applies the changes:
WLC.siemens.com
WLC.siemens.com
SCALANCE WLC711 CLI Reference Guide
:mitigator# analysis
:mitigator# apply
wcswip
Specifies the IP address of the Remote Data Collection Engine
Specifies the time interval (in seconds) that the Analysis Engine will poll the
Remote Data Collection Engine. The values from 3 to 60 are accepted.
Specifies the number of times the Analysis Engine will attempt to poll the Remote
Data Collection Engine to maintain connection status before it stops sending
requests. The values from 0 to 20 are accepted.
:mitigator# wcswip 123.456.789.101 3 1
:mitigator# apply
command to implement the changes.
apply
command is accessible from the mitigator
command.
wcswip
command to
apply
Radar Commands
wcswip
176