Siemens scalance WLC711 Reference Manual page 370

l3presence
As of Release 9.21, you can access Layer 3 on a b@ac topology when l3presence is disabled. For
releases prior to 9.21, you must enable Layer 3 on a b@ac topology to access Layer 3 commands in the
topology:<named-topology>:l3 context. Use the
a b@ac topology. The
context of the CLI for b@ac topologies.
l3presence enable | disable
Parameters
enable
disable
Example
The following example enables Layer 3 on a b@ac topology:
WLC.siemens.com
mode
Use the command to change the mode of an existing b@ac, b@ap, or routed topology. You can
mode
configure the mode of a topology only if the topology is not associated with a policy. The
command is available from the topology:<named-topology> context of the CLI for b@ac, b@ap, and
routed topologies.
b@ac
mode b@ap |
Parameters
b@ap | b@ac | routed
Example
The following example changes the mode of the topology to b@ap:
WLC.siemens.com
name
Use the command to change the name of an existing b@ac, b@ap, or routed topology. The
name
command is available from the topology:<named-topology> context of the CLI for b@ac, b@ap, and
routed topologies.
name topology name
Parameters
topology name
SCALANCE WLC711 CLI Reference Guide
command is available from the topology:<named-topology>
l3presence
Enables Layer 3.
Disables Layer 3.
:topology:bridged_ac1# l3presence enable
routed
|
Specifies the mode of the topology.
:topology:bridged_ac1# mode b@ap
Specifies the name of the topology.
command to enable or disable Layer 3 on
l3presence
topology Commands
l3presence
mode
name
370