•
foreign-gateway
•
foreign-range
on page 356
•
gateway
on page 356
•
lease-default
on page 357
•
lease-max
on page 357
•
mode
on page 358
•
range
on page 358
•
show
on page 359
•
wins
on page 359
dhcp-servers
Use the
dhcp-servers
available from the topology:<named-topology>:l3:dhcp context of the CLI for b@ac and routed
topologies. This command is visible only when mode is set to relay. See
dhcp-servers (A.B.C.D [,A.B.C.D [...]]) | none
Parameters
A.B.C.D [,A.B.C.D [...]] Specifies qualified IPv4 address of DHCP relay servers.
none
Example
The following example sets the IP address of the DHCP relay server as 10.0.1.10:
WLC.siemens.com
WLC.siemens.com
dls
Use the
command to enable or disable DLS (HiPath Deployment Services). The
dls
available from the topology:<named-topology>:l3:dhcp context of the CLI for b@ac and routed
topologies. This command is visible only when mode is set to local. See
After you run the
dls
dls enable | disable
Parameters
enable
disable
SCALANCE WLC711 CLI Reference Guide
on page 356
command to configure DHCP relay servers. The
Clears DHCP relay servers.
:topology:test:l3:dhcp# mode relay
:topology:test:l3:dhcp# dhcp-servers 10.0.1.10
command, run the
apply
Enables DLS.
Disables DLS.
dhcp-servers
mode
mode
command to implement the changes.
topology Commands
dhcp-servers
command is
on page 358.
command is
dls
on page 358.
353