Siemens scalance WLC711 Reference Manual page 137

rss-threshold
Use the
rss-threshold
command is accessible from ap:defaults:37xx, ap:defaults:38xx, ap:defaults:3801, and ap<serial> radio
contexts for ap37xx, and ap38xx APs when probe-suppression is enabled.
rss-threshold dBm
Parameters
dBm
Usage
Probe requests from unassociated clients are not responded to if RSS is less than the RSS-threshold.
Assoc requests from clients that are not associated are not responded to if RSS is less than the RSS-
threshold. Probe requests from clients that are associated are not responded to if the client's averaged
RSS (after including the Probe Request) is less than the RSS-threshold.
Example
The following example sets the RSS threshold on radio 1 of AP 1111111111113705 to -80 dBm:
WLC.siemens.com
rts
Use the command to specify the size of the Request to Send (RTS) threshold. The
rts
accessible from all radio contexts of the CLI.
rts value
Parameters
value
Example
The following example sets the RTS packet size to 256:
WLC.siemens.com
stbc
Use the command to enable or disable the 11n advanced STBC feature. The
stbc
accessible from the ap:defaults:ap37xx, ap38xx, ap3801, and <serial> radio1 and radio2 contexts of the
CLI.
stbc enable | disable
SCALANCE WLC711 CLI Reference Guide
command to set the RSS threshold on an AP radio. The
Specifies the RSS-threshold in dBm.Defaults to -90 if probe suppression is enabled.
Supported values are -50 to -100 dBm.
:ap:1111111111113705:radio1# rss-threshold -80
Specifies the Request to Send packet size threshold. The value for the rts value is
256 to 2346.
:ap:defaults:11n:radio2# rts 256
ap Commands
rss-threshold
rss-threshold
command is
rts
command is
stbc
137