How Do I Configure Parameter Groups - Siemens SIMATIC BATCH Operating Manual

12.8.2

How do I configure parameter groups?

The configuration of a control strategy as dynamic unit parameters takes place at the interface
blocks IEPH or IEOP, same as the control strategy configuration.
Note
Control strategy assignment at the IEPAR_ENUM block
● There may be only one dynamic control strategy parameter. At each IEPAR_ENUM block,
you must select the same control strategy type at the "SP_VAL" connection.
● The "SP_VAL" connection of an IEPAR_ENUM interface block interconnected in a chart
must always be assigned to an enumeration or a control strategy data type.
The validation signals an error in the BATCH configuration dialog in both cases. This error
must be eliminated prior to the download.
Requirements
● The software and the project have been updated.
● You are using BATCH blocks from the current block library.
Description of configurations
The configurations below give you an exemplary overview of the different configuration steps
and the possible applications of your processes.
SIMATIC BATCH V8.2
Operating Manual, 02/2016, A5E35958174-AA
12.8 How do I configure and use dynamic unit parameters?
Recommended procedure
695