Find" Dialog - Siemens SIMATIC BATCH Operating Manual

Selecting locations
The "Location" dialog lists all recipe unit procedures with their locations of the selected data
type (source, destination, over).
Locations are configured under equipment properties in SIMATIC Manager.
After selection of a location, the properties "Reference", "Location and "Location ID" will be
adopted in the properties dialog of the recipe function in the "Transfer parameters" tab.
Process mode
In process mode, only the location can be changed in the control recipe but not the reference.
"New assignment" button
Opens the dialog in which you select a unit so that you can assign the respective location.
"Edit assignment" button
Opens a dialog in which you can alter an existing allocation.
Additional information
"Transfer parameter" tab (Page 781)
Additional information is available in the online help on SIMATIC Route Control in the section
"Interaction between SIMATIC BATCH and SIMATIC Route Control".
14.1.11.20

"Find" dialog

Find recipe elements
You can use the "Find" dialog to locate specific elements in recipes, batch, or libraries. You
can use the search function in BatchCC, in the BATCH Recipe Editor, and in the BATCH OS
controls. The hit locations are shown in a table. If you double-click a table object, the
corresponding recipe opens in the editor and the hit location is highlighted in color. The search
result can be saved as a text file.
You can search for the following elements, for example:
● Text
● Data such as data type, control strategy type, unit, library reference, category, or material
● Structures such as cross-references, source and target interconnections, jumps,
monitoring, command steps, operator instructions, and synchronization
● Materials
● Status and extended status
● Recipe unit procedures, recipe steps and transitions
● Parameters
SIMATIC BATCH V8.2
Operating Manual, 02/2016, A5E35958174-AA
Context help references
14.1 Dialogs
847