Siemens SIMATIC BATCH Operating Manual page 731

The default setting of this property is "Yes".
Area-oriented WinCC messages
With the setting in the configuration, you decide whether or not WinCC messages are displayed
on the PCS 7 OS area oriented. Previously, the unit matching the WinCC message was
displayed in the "Area" column.
If the option "Yes" is set, the relevant OS area ID is used in the "Area" column of the WinCC
message. The OS area ID can be set in the settings of the plant hierarchy.
If the option "No" is set, the name of the relevant unit is displayed in the "Area" column.
The setting only applies to WinCC messages that have a reference to an OS area ID. WinCC
messages that are not assigned to any OS area ID are generated without an area ID.
Permit start of IEPH/IEOP in error state
You use this project setting to specify whether a start command is sent by SIMATIC BATCH
to the IEPH/IEOP interface blocks in error state.
If an error is pending at the IEOP/IEPH interface blocks, SIMATIC BATCH has so far not sent
a start command to the block. The start command could be operated at the batch but was not
sent to the block. The default setting of this property is "No".
Using optimized startup characteristics for SFC type
If you select the "Yes" property for the project setting, the control strategy, the setpoints and
the start command are sent to the block simultaneously when a batch starts an SFC type.
This starts up the SFC type faster.
If you select "No", the control strategy and the setpoints are sent first followed by the start
command.
The default setting of this property is "Yes".
"OK" button
Exits the dialog and saves your settings.
"Standard" button
When you click this button, all project settings you have changed in this tab are reset to the
default settings.
Apply
Saves your settings without closing the dialog.
"Cancel" button
Exits the dialog without saving your settings.
SIMATIC BATCH V8.2
Operating Manual, 02/2016, A5E35958174-AA
Context help references
14.1 Dialogs
731