Siemens SIMATIC BATCH Operating Manual page 742

Context help references
14.1 Dialogs
General > Release batches automatically
If you set the value of this property to "Yes", newly added batches are automatically released
once they are created.
Default setting: No.
General > Open operator dialogs automatically
If you set the value of this property to "Yes", all configured operator dialogs will open
automatically in the control recipe view in BatchCC when a control recipe is opened. Use the
value "No" to prevent all operator dialogs of open batches from being opened and displayed
immediately.
Default setting: Yes.
General > Extended continuous mode
If you set the value of this property to "Yes", equipment phases continue to run in continuous
mode even after the end of the batch and are not completed automatically.
Equipment phases in extended continuous mode can be applied to other batches.
With the default setting "No", equipment phases are automatically completed at the end of the
recipe unit procedure or at the end of the batch and do not continue to run when the
corresponding unit is released.
Default setting: No
Close and archive > Archive automatically
If you set this property value to "Yes", batches that are completed, aborted or stopped will be
closed and archived automatically . Batches requiring an electronic signature for these actions
will be ignored.
Default setting: No
Close and archive > Wait time after closing
You specify the wait time between the manual closing and the archiving of the batch. To do
this, select the required wait time in days from the selection box. The preset default value is
seven days. Enter a number between 0 and 30.
Structure changes > Allow online structure changes
If you set this property value to "Yes", online structure changes on this BATCH client are
possible. The default setting for this property is "No" or not allowed. Note that there are
additional requirements for recipe structure changes in runtime. A reference to the topic is
listed at the end of this section.
Default setting: No.
742
SIMATIC BATCH V8.2
Operating Manual, 02/2016, A5E35958174-AA