General" Tab (Transition Properties); General" Tab (Jump Properties) - Siemens SIMATIC BATCH Operating Manual

"Monitoring time" in seconds text box
You specify the monitoring time and a system message will be generated if the current ROP
runtime is greater than or equal to the monitoring time you have set. Monitoring is disabled
when you enter a monitoring time of "0".
Scaling the run time:
You can use scaling functions to make processes quantity-dependent. Depending on the
specific quantity of the batch, the duration of a step is also corrected via the set scaling function.
The linear and quadratic scaling functions are available by default.
"Overwrite runtime" check box.
If you select this check box, the "Run time" text box can be edited. You can then change or
overwrite the run time calculated by the system. If you clear the check box again, the run time
calculated by the system is then entered and used.
Description:
You can enter an explanatory description for the unit recipe here.
14.1.10.8

"General" tab (transition properties)

Name:
A name is automatically assigned to a transition.
Description:
Enter an explanatory text here.
14.1.10.9

"General" tab (jump properties)

Name:
A name is automatically assigned to a transition.
Description:
Enter an explanatory text here.
Jump destination:
Select the desired destination for the "Jump" object from the selection box. Only available jump
destinations are offered for selection.
SIMATIC BATCH V8.2
Operating Manual, 02/2016, A5E35958174-AA
Context help references
14.1 Dialogs
823