Siemens SIMATIC BATCH Operating Manual page 549

Limitations
Prevented jump destinations when configuring in the Recipe Editor:
● A jump can only be performed within a recipe level (RUP/ROP).
● It is not possible to jump into or out of a simultaneous recipe branch.
● Jumps beyond synchronization lines.
Project setting to allow jump destinations beyond synchronization lines
A selection box for permitting unsafe jump destinations is available in the project settings dialog
under Options > Settings > Project Settings in the BatchCC, "General" tab. This selection box
is cleared in the default project settings. When it is enabled, unsafe jumps are permitted beyond
synchronization lines. These jumps make the recipe execution unsafe. Steps may be started
twice or recipes may stop.
Note
Pay attention to the following when using jump destinations beyond synchronization lines:
● Recipe elements in other recipe unit procedures are not started.
● Recipe unit procedures not yet active remain inactive.
Special system characteristics for monitoring
If you use a jump to jump to a monitored area, the monitoring is started. If you jump out of a
monitored area, the monitoring is ended.
Inserting
On inserting, the Recipe Editor automatically forces an alternative branch with a jump without
a jump destination.
Proceed as follows to insert jumps in the diagram in the BATCH Recipe Editor:
1. Select the Insert > Jump menu command or the corresponding button in the toolbar.
2. Click the required location in the opened recipe until the mouse pointer shows the jump
symbol to insert a jump.
3. You configure the transition of the jump on the "Condition" tab of the properties dialog and
then in the Transition Wizard. You configure the jump destination on the "General" tab of
the properties dialog. Alternatively, you can also select the jump object in the Recipe Editor
and, keeping the left mouse button pressed, drag it onto the required jump destination
object. Then release the left mouse button.
Additional information
Example of a recipe jump (Page 550)
SIMATIC BATCH V8.2
Operating Manual, 02/2016, A5E35958174-AA
BATCH Recipe Editor
10.4 Creating recipes
549