Batches > Predefined Batch Name - Siemens SIMATIC BATCH Operating Manual

Structure changes > Active batches have to be held
If the "Allow structure change" property is set to "Yes", this property can be used. Online
structure changes are only possible if active batches are held. After completing the online
structure change, the batches must be resumed.
Default setting: Yes.
"OK" button
Exits the dialog and saves your settings.
"Standard" button
When you click this button, all project settings you have changed in this tab are reset to the
default settings.
"Apply" button
Saves your settings without closing the dialog.
"Cancel" button
Exits the dialog without saving your settings.
"Help" button
Opens the online help for this dialog.
Additional information
Requirements for online structural changes (Page 461)
Extended continuous mode (Page 404)
14.1.2.10 Batches > Predefined batch name
In this dialog, you define the static and dynamic content for the automatic generation of batch
names.
Batch names that are created with predefined names automatically receive a file extension
(file suffix). You recognize the file extension by the underscore followed by a number, starting
with one. The numbers are incremented automatically.
Requirement
To use predefined batch names, set the value of the "Use predefined batch names" property
to "Yes". The property is found in the project settings under Batches > Settings.
SIMATIC BATCH V8.2
Operating Manual, 02/2016, A5E35958174-AA
Context help references
14.1 Dialogs
743