Siemens SIMATIC BATCH Operating Manual page 474

BATCH Control Center
9.9 Report creation and archiving of batch data
Image 9-27
Backup and restore
If the configuration was created successfully and the "PH archiving" method is adopted in
SIMATIC BATCH, even after a backup followed by a restore, nothing changes. If, however, a
backup file was used that was created at a time when the "PH" archiving method was not
active, the "Update process cell" function is absolutely mandatory in the BatchCC following a
"Restore". In addition to this, the relevant URL in the project settings must be adapted in the
"Report creation" folder.
Note
In this case, the same restrictions relating to completeness of the data apply as described in
the section "Changing the archiving method".
Information on batch commands
● "Close" command
The "Close" command is no longer available since a batch implicitly adopts the status
"completed and closed" when all the batch data has been transferred to the PH archive.
● "Archive" command
The "Archive" command changes the batch to the "Archiving" status. As soon as the batch
data is transferred to the PH, the batch status changes to "Archived". As of this version, it
is also possible to comment on the batch or batch elements up to the "Archived" status.
474
"Report creation" folder
SIMATIC BATCH V8.2
Operating Manual, 02/2016, A5E35958174-AA