Siemens SIMATIC BATCH Operating Manual page 508

BATCH Recipe Editor
10.3 Recipe topology
Example of synchronization (blocking)
In the screenshot shown below, the synchronization lines (blocking) between the two recipe
unit procedures (RUPs) shown cause the following reactions:
● Line 1: ROP 10 and ROP 6 start steps 20, 5, 13
● Line 0: ROP 5 and ROP 14 start steps 11, 16
Image 10-2
Changing over between blocking and non-blocking
You can change the blocking or non-blocking effect of each synchronization point. Follow the
steps outlined below:
1. Select the synchronization point.
2. Select the command "Properties" in the shortcut menu of the synchronization point.
3. Select/clear the "Blocking" check box.
4. Confirm with "OK".
508
Blocking synchronization point
SIMATIC BATCH V8.2
Operating Manual, 02/2016, A5E35958174-AA