Synchronization Line" Dialog Box; General" Tab (Rph Unit Class Properties) - Siemens SIMATIC BATCH Operating Manual

Context help references
14.1 Dialogs
14.1.10.3

"Synchronization line" dialog box

Name:
Here, enter a name for the synchronization point.
Blocking / non blocking
With this selection, you can decide whether or not processing should wait at this
synchronization point for the recipe unit procedures linked via the synchronization line.
Additional information
Synchronization between recipe unit procedures (Page 507)
Configure synchronization lines (Page 556)
14.1.10.4

"General" tab (RPH unit class properties)

Function:
You receive a selection list of the EPH-type phases entered in the basic engineering. The
selection is restricted to the unit class and permitted units selected in the RUP.
Unit class:
The unit class selected in the "Allocation" tab in the RUP is displayed.
Control strategy:
The control strategies for the phase entered in the basic engineering are displayed. Select the
desired control strategy here. The parameters belonging to the control strategy are displayed
in the "Parameters" tab and can be changed there.
Note
Only the default values of parameters displayed for the currently set control strategy can be
modified. Browsing through all control strategies for the phase and the respective setting of
new parameter values is not possible. When a change is made to a different control strategy,
the default parameter set from the basic engineering is always displayed to begin with and can
be changed for the particular current control strategy.
Preferred unit:
The selected preferred unit for the unit class is output in the RUP in the "Allocations" tab.
818
SIMATIC BATCH V8.2
Operating Manual, 02/2016, A5E35958174-AA