Transition (Insert Menu); Alternative Branch - Siemens SIMATIC BATCH Operating Manual

BATCH Recipe Editor
10.4 Creating recipes
6. Configure the transition of the jump. This should end the monitoring. Operand 1 is the RPE
status and Operand 2 is a constant. Select the recipe element "filling_1" and leave the
"Status" attribute as is. Select the "completed" value for Operand 2 and close all dialogs.
7. Enter 2 seconds, for example, as the run time in the properties dialog.
Final result
You have now configured all the recipe elements and transitions in your example recipe.
Release the recipe and use it in a batch in process mode.
10.4.5.11

Transition (Insert menu)

Overview
You use this function to insert a transition into your master recipe.
In the recipe window with the units, the recipe operations can be executed without a transition.
You can, however, also insert several transitions between steps and synchronization points.
In the step sequence window for the recipe operation, when you insert a transition, you also
insert a step so that there is always a step between two transitions. Depending on the point at
which you insert the transition, the order of the step and transition may be reversed.
Properties
Data on the "General" and "Condition" tabs can be edited. To form the transition conditions,
the process tags defined in the corresponding recipe level (parameters from the properties of
an ROP or RUP), constants, and all the values acquired with the TAG_COLL block can be
used.
Text strings with more than 32 characters within a transition query are not supported.
10.4.5.12 Alternative branch (Insert menu
Overview
In the BATCH Recipe Editor, this function inserts an OR divergence.
An alternative branch consists of at least two vertically arranged sequences joined at top and
bottom by a single horizontal line. Each alternative branch begins with a transition whose
results determine which branch is executed. The transitions should be created so that the
results select only one path.
Selection
If you click one of the two horizontal lines, you select the entire alternative branch. If you click
one of the lines that join the horizontal lines, a sequence is selected.
546
SIMATIC BATCH V8.2
Operating Manual, 02/2016, A5E35958174-AA