Siemens SIMATIC BATCH Operating Manual page 481

Principle
The batch report can be viewed or printed out at any time between the planning of a batch and
its completion. The report always includes the data up to the latest completed control recipe
phase including the corresponding messages and measured values. The batch report lists the
minimum and maximum values of the process tags in a table for the period during which the
level (procedure, RUP, ROP) was active; this is then followed by the trend diagrams.
The batch report can be opened and printed in BatchCC. This is done by selecting the batch
and opening the shortcut menu:
● Print > Select report template: The batch report is printed immediately without preview on
the screen.
● Print preview > Select report template: The batch report is displayed in the print preview
window.
Note
System characteristics
There is a delay when collecting the data for messages and measured values. The delay time
depends on the batch size.
Monitoring is canceled when the recipe is completed or runs out of the monitored area. The
status "Aborted" is therefore always listed in the batch report.
SIMATIC BATCH V8.2
Operating Manual, 02/2016, A5E35958174-AA
9.9 Report creation and archiving of batch data
BATCH Control Center
481