Roadmap For Configuring Switch Ethernet Ports; Summary Of Switch Ethernet Port Configuration Cli Commands - Avaya G430 Manual

Ethernet ports

Roadmap for configuring switch Ethernet ports

For basic configuration of a switch Ethernet port, use the commands listed below. You can
also configure the following features on a switch Ethernet port:
• Advanced switching features, including VLANs. For more information, see
switching
• VoIP queuing. To configure VoIP queuing on a switch port, configure a VLAN for the port.
Then configure VoIP queuing on the VLAN. For more information about VoIP queuing,
see Commands used to configure QoS parameters
• Access control policy lists and QoS policy lists. To configure policy lists on a switch port,
configure a VLAN for the port. Then configure policy on the VLAN. For more information
on policy lists, see
• SNMP Link Up and Link Down traps. For more information, see
configuration

Summary of switch Ethernet port configuration CLI commands

For more information about these commands, see the Avaya Branch Gateway G430 CLI
Reference.
set port duplex
set port enable |
disable
set port flowcontrol
set port level
set port name
set port negotiation
200 Administering Avaya G430 Branch Gateway
on page 327.
Policy lists
on page 309.
Command
Comments? infodev@avaya.com
on page 557.
Description
Configure the duplex type (full or half-duplex) of an
Ethernet or Fast Ethernet port or range of ports
You can configure Ethernet and FastEthernet
interfaces to either full-duplex or half-duplex. The
duplex status of a port in auto-negotiation mode is
determined by auto-negotiation. When auto-
negotiation is enabled, an error message is generated
if you attempt to set the transmission type of auto-
negotiation Fast Ethernet ports to half-duplex or full-
duplex mode.
Enable or disable a port or a range of ports
Set the send/receive mode for flow control frames
(IEEE 802.3x or proprietary) for a full-duplex port
Set the default packet priority level for untagged
packets
Configure a name for a port
Enable or disable auto-negotiation on the port
on page 240.
SNMP trap
Advanced
October 2013